After receive Dr.wellness hydrogen inhalation machine（YL-3000）， what should you do ?

First, thank you choose Dr. wellness hydrogen inhalation.
When using the machine for the first time, pls notice the following:
Prohibit:
Do not use in confined spaces!
Flammable gas, no ignition test!
Do not block the gas outlet when the machine is running!
Reminder: Please unplug the plugs of H and O outlets before turning on the machine.

Warn:
Keep away from fire when the machine is running!
When leaving the machine, please pause or turn off the machine!
Maintain:
Please add TDS=0 distilled water.
Add water to the new machine and soak for 10 minutes, drain the water, then add water again start to use.

The YL-3000 operate video as following, you can look at and follow it:

How To Use:

1.Turn on the power, connect the water pipe.

Press the gray clamp with one finger and remove the plug with the other hand( remeber one finger must press the gray clamp)After removing the plug, insert the water supply pipe firmly into the tank and put the other end into purified water or distilled water (TDS=0).

3.Press the water adding button on the screen, it will add water automatically.

2.Timing function：press the plus and minus signs on the left to set the timer. You can set it for 1-8 hours.

3.The Flow Rrate Range: press the plus and minus signs on the right to adjust the flow rate from 1500ml to 3000ml. There are 16 gears to adjust.

4. One person inhales the H2&O2 Connection

First connect the Y tube then  connect the cannular like following, then you can inhale the H2&O2 now.

5.Two people inhale together

Use" Y "connector and "T" connector to connect the nasal cannular on both sides like following,then two people can inhale hydrogen at the same time

6.Make hydrogen water 

Use a tube, one end connect to H2 outlet, the other end connect into Hydrogen dissolved rod, leave the O2 output open, put rod into water, after 5-7 minutes later, can drink the hydrogen water.

7. Wear a H2 eye mask and earplug while inhaling H2.

One side connect cannula to inhale H2, and another side connect the eye mask and earplug.

8. Drain Water Connect the drain pipe.

Unplug the add water pipe and plug it with the original plug (when pulling it out, remember to press the gray retaining spring with one finger while pulling it out).

Use the same method to remove the drain pipe plug and install the drain pipe，the drain pipe the other end put it in a container ，then press the "drain water" botton on the screen， It will drain water automatically.（Please note that the drained water cannot be reused）.

Other Customer FAQs

• How to turn off the light of the Dr.wellness YL-3000 hydrogen generator?

          Pls check this video: https://www.youtube.com/watch?v=aM9HQkylqd4

• how to use the water collector of the hydrogen inhaler?

  Pls check this video: https://youtube.com/shorts/MxDUHisZACc?si=DbF0E3iUXllx1uSM